|
The Vampmaster -> RE: How do I make rounded edges? (3/9/2002 22:57:24)
|
Sorry for the delay gail. I normally only check this on the weekends.
The story is as follows, in a table I like to divide the cells in lines and columns. Whan I ment is that the first row of cells, should be done accordingly to your table but whith a 1X1 clear pixel graphic modified.
Lets asume you want a first table of lets say 760 width with one column of 150 pixels, one column of 460 and a last column of 150 pixels.
you ask FP to draw a table of 760 pixels three columns and at least two rows.
then you go and select the first column, of cells, (both of them at the same time) and select them to be 150 pixels width. You select the middle ones, (again both at the same time) and select them to be 460 width. Finally you select the last two cells in the right column (did I mention both at the same time?) and select them to be 150 pixel width.
Now you have the basic layout for a page with left and right tabs and a center one, but as everybody knows these numbers are not yet completely fixed, so you create a 1X1 gif graphic where the only pixel is a transparent one, and go to the first cell in the first column, there you insert the graphic, and modify it to be 150 pixels width by 1 pixel height. Do the same in the first row cell but middle column and modify it to be 460 pixel widht by 1 pixel height. Finally you do the proper with the first row cell right column.
If you did it right, it appears now that you only have one row left. As a matter of fact what you just did was setup a clear layout, now you can insert more tables into those cells, or insert more rows by going to the last cell and pressing tab.
Hope this helped a bit.
The Vampmaster
|
|
|
|
